Iron Remover

Category:
Ask about product

The unit treats water by removing iron and manganese using a specialised catalytic bed. The individually programmed iron remover counts down the time since the last regeneration and restores the water treatment properties of the filter medium by flushing out iron and manganese deposits. After the regeneration process, the unit is ready for operation. Suitable for use with air membrane hydrophore (galvanised).

The device treats water by removing iron, manganese and hydrogen sulfide using a specialized filtration bed. Individually programmed iron remover calculates the amount of water which has been treated. The device washes out the mechanical impurities from the filtration bed. After the regeneration process, the device regains its filtration capacity, thus it can again treat water effectively. Before using the device, please read this installation manual and comply with all rules for safety start-up and operation of the device.

Compliance with the manual ensures safety and full performance of the purchased device. Lack of compliance may cause damage in health and material. Installation of the device must be in accordance with the applicable standards and law requirements.

 

Properties:

  • control valve with ceramic discs giving high
    mechanical endurance and quiet operation,
  • automatic regeneration,
  • simple construction,
  • output and input signal connectors
  • no additional chemicals needed for
    regeneration,
  • hygienic certificate
VALVE MODEL

RX67C1, RX75
Application

drinking water
Working temperature

5 ˚C – 50 ˚ C
Working pressure

>6,5
Power supply

110 – 230 V,
50-60 Hz

Recommended by FITaqua

  • Iron Remover Parallel with RX107 Aeration valve

    The unit treats water by removing iron and manganese using a specialised catalytic bed in two parallel-connected cylinders. It is equipped with an aeration unit (compressor, aeration tank, and valve) to ensure optimal oxidation of iron and manganese. The individually programmed iron remover measures the volume of water and regenerates the filter medium by flushing out iron and manganese deposits. After the regeneration process, the unit is ready for operation. Suitable for use with membrane hydrophores, where chemical reagents cannot be used for regeneration.

    Read more

  • Iron Remover with RX107 Aeration valve

    The unit treats water by removing iron and manganese using a specialised catalytic bed. It is equipped with an aeration unit (compressor, aeration tank, and valve) to ensure optimal oxidation of iron and manganese. The individually programmed iron remover measures the volume of water and regenerates the filter medium by flushing out iron and manganese deposits. After the regeneration process, the unit is ready for operation. Suitable for use with membrane hydrophores, where chemical reagents cannot be used for regeneration.

    Read more

  • Iron Remover with KMnO₄

    The unit treats water by removing iron and manganese using a specialised catalytic bed. The individually programmed iron removal unit measures the volume of water and regenerates the filter medium by flushing out iron and manganese deposits and restoring the bed with a chemical reagent (potassium permanganate, KMnO4). After the regeneration process, the unit is ready for operation.

    Read more